Why we can't use fake motor oil

https://www.sdrboil.com/fully-synthetic-or-synthetic-turbine-oil-sp-5w-30.html

Why we can't use fake motor oil

Oil as the engine's “blood”, the importance of which I believe we can know without saying. In order to make the equipment run better, don't try to cheaply choose inferior lubricant.

Fake oil does not have a thick enough oil film to prevent wear and tear of the parts.

There is rapid relative sliding between the piston and the cylinder, the main shaft and the shaft tile. In order to prevent the surface of the parts from wearing out due to sliding, it is necessary to form a layer of oil film on the two sliding surfaces. An oil film of sufficient thickness separates the relatively sliding parts, thus reducing wear. Counterfeit oils usually do not produce a sufficient film of oil, which can cause increasing engine wear and lead to a variety of problems.

Counterfeit oil does not help dissipate heat, which can lead to high engine temperatures.

Motor oil has a low specific heat capacity and does not have a cooling effect by itself. However, when the engine is working, the fuel combustion will produce a lot of heat energy, which requires the oil to be able to bring the heat back to the fuel tank and then emit it out. Fake motor oil is difficult to help dissipate heat, easy to lead to dry friction, resulting in high engine temperatures and other conditions.

Fake motor oil has poor cleaning performance and cannot clean the engine.

Good motor oil can flow through the engine parts on the carbide, sludge, wear metal particles through the cycle back to the oil tank. However, fake motor oil has poor cleaning performance, if you use fake motor oil, you will find that the engine is easy to produce carbon, sludge and other dirt.

Poor sealing performance of fake motor oil can easily lead to cylinder pressure leakage, increasing fuel consumption and emissions

The oil can form a “sealing ring” between the piston ring and the cylinder wall, reducing gas leakage and ensuring sufficient pressure in the cylinder. Fake oil does not have this effect, therefore, the use of fake oil can easily lead to cylinder pressure leakage, when the engine can not output enough power, it will cause high fuel consumption, emissions increase, oil consumption too fast and a series of problems.

Fake oil has poor anti-rust properties, accelerating the corrosion of metal parts.

Lubricating oil can be attached to the surface of parts to prevent water, air, acidic substances and harmful gases from contacting the parts. However, fake motor oil has poor adherence ability, so it accelerates the oxidation of metal parts and leads to serious rusting.

Counterfeit engine oil has poor lubricating ability and cannot cushion shock loads

When the pressure at the cylinder port of the engine rises sharply, the load on the piston, piston chip, connecting rod and crankshaft bearings becomes large, but the load can be reasonably cushioned by the transfer lubrication of the bearings. The poor lubricating ability of fake oil makes it difficult to cushion such loads, and over time, this can cause mechanical failure.

The use of fake oil, the light is a constant failure, the heavy is pulling cylinder burning tile. Saving a little money on maintenance results in shorter engine life or even early retirement. Nippon lubricant raw materials are purchased globally, the use of international advanced technology production of Nippon lubricant can release the extraordinary power of the car, creating the ultimate driving experience.