Lubricants just add and don't change? The more you add the better?

https://www.sdrboil.com/c5-sp-fully-synthetic-lubricants.html

Lubricants just add and don't change? The more you add the better?

Add as much lubricant as you can?

Just add and don't change?

Is that right?

The answer is of course no!

Although we all know that the importance of lubricating oil. Engine lubricants are used in the engine to effectively reduce friction between internal components and promote good engine operation. Lubricant in the car, is an indispensable dose of “prescription”, with it, will make our driving process smoother. Some car owners believe that the lubricant can add more and more, every time to fill up, for fear that their cars “not eaten”. This is certainly not true.

In terms of car maintenance, car owners have their own behavioral habits, can be divided into two major factions: one is as long as the basic maintenance, other aspects are not too much attention to the Buddhist car owners; the other is the size of the aspects to be maintained, that more maintenance of more peace of mind of the positive faction.

Even if it is important to maintain the “positive faction” of the owners, but also fall into some misunderstandings, such as looking at the lubricant is less, continue to add, think add the fuller the better.

This is a misunderstanding. Lubricant is not the more the better, the lubricant also needs to be replaced, often added to the not replaced will reduce the performance of the lubricant.

Ribang small classroom interpretation:

Too much lubricating oil will have a bad effect, because too much lubricating oil from the cylinder and piston clearance into the combustion chamber combustion and the formation of carbon deposits. These carbon deposits also increase the engine's compression ratio, increasing the tendency to produce detonation. In addition, carbon deposits in the cylinder is red-hot state will cause premature combustion, such as falling into the cylinder will intensify the cylinder and piston further wear and tear, but also further contaminate the quality of lubricating oil. In addition, too much lubricant will increase the crankshaft connecting rod stirring resistance, increase fuel consumption. Therefore, the amount of lubricating oil should be controlled between the upper and lower scales of the oil dipstick is good.

Lubricating oil in the process of use, will be because of pollution, oxidation and other aspects, reduce the quality of oil, but also because of some consumption, the number of reduced. If just continue to add new lubricant in the original lubricant, making the old oil and new oil combination, will greatly reduce the performance of the lubricant.

In fact, in our daily lives, there are many “we think” of the misconceptions affecting the normal judgment of the car care and maintenance. Therefore, the lubricant is not added the more the better, if the previous owners into the misconceptions, read this article will be corrected in a

timely manner, so as to take better care of the car.